M7 let tank

M7 let tank

LandUsa
CatégoriePansrede køretøjer
TypeLet tank
BeskrivelseAlbum 94 Walk-around fotos af "M7 Light Tank"

Fotogalleri på en M7 Light Tank, Bestilt som en efterfølger til den populære M5 kampvogn gik den aldrig længere end prototypestadiet, kun 7 blev bygget. M5 kunne ikke konkurrere med M4 Sherman.

Tekniske specifikationer: Armement: canon de 75mm et une mitrailleuse MG 0.3″ Moteur: Wright R975, 9 cyl. Whirlwind radial, gas, 340 hp Vitesse: 50 Km/h Autonomie: 160 Km Poids: 25t

Wait, Searching M7 Light Tank for you…

Se også:

Anden Verdenskrig: Den definitive visuelle historie fra Blitzkrieg til atombomben (DK Definitive Visual Histories) - Amazon Anden Verdenskrig Kort efter Kort (DK Historie Kort efter kort) - Amazon


The M7 Medium Tank, initially conceived as the T7 Light Tank, was a World War II armored vehicle project by the United States intended to replace the M3/M5 “Stuart” light tank series. Due to successive requirements for increased armor and firepower, the tank grew significantly in weight during its development, ultimately exceeding the specifications for a light tank and leading to its reclassification as a medium tank.


Development and Classification Changes

The T7 Light Tank Program

  • Initial Requirement: The program began in 1941 to design a new light tank, aiming for a combat weight of under 14 short tons (12.7 tonnes), armed with a 37 mm gun, and featuring a low silhouette.
  • Weight Creep: As development progressed through prototypes (T7E2, T7E3, T7E4), the Ordnance Department and Armored Force requested a heavier main gun—first the British 57 mm (6-pounder), and finally the American 75 mm M3 gun (the same as the M4 Sherman).
  • Armor Increase: Correspondingly, armor thickness was increased to handle the heavier armament and match contemporary threats, pushing the weight past the original 14-ton limit.

Standardization and Cancellation

  • Reclassification: By the time the T7E5 prototype was ready, its combat weight had reached approximately **24.5 short tons** (22.2 tonnes). It was standardized as the **M7 Medium Tank** in August 1942.
  • Production Failure: International Harvester Co. was contracted to build 3,000 M7s, but production models were found to be even heavier than the prototypes, approaching 29 short tons.
  • Project Cancellation: The M7 was deemed **inferior** in performance and reliability to the already standardized and mass-produced **M4 Sherman**, while offering no significant operational benefit. Production was halted in July 1943 after only **13 units** were fully completed.

Technical Specifications (M7 Medium Tank)

General Characteristics

Specification Detail
Designation Medium Tank M7
Besætning 5 (Commander, Gunner, Loader, Driver, Co-Driver)
Mass (Combat) Approx. 24.5 tonnes (54,000 lb)
Længde 5.23 m (17 ft 2 in)
Bredde 2.84 m (9 ft 4 in)

Armament and Armor

Component Detail
Main Armament 1 x 75 mm M3 L/40 gun
Ammunition Capacity 71 rounds (75 mm)
Secondary Armament 3 x .30 cal (7.62 mm) M1919A4 machine guns
Armor (Max Frontal) Up to 64 mm (2.5 in) on the gun shield
Hull Construction Predominantly cast homogeneous steel with sloped frontal armor.

Mobility and Powerplant

Component Detail
Motor Continental R975-C1 9-cylinder radial gasoline
Engine Power 400 hp (298 kW)
Maximum Speed Approx. 48 km/h (30 mph) on road
Ophængning Vertical Volute Spring Suspension (VVSS)

The M7 project represents a transitional design in American tank development, illustrating the difficulty of balancing speed, armor, and firepower as battlefield requirements evolved in World War II.


Visninger : 3207

Efterlad et svar

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong> 

Kræves

Dette websted bruger Akismet til at reducere spam. Få mere at vide om, hvordan dine kommentardata behandles.